Go Top
SOCLE > ASIC Design Service > Mixed-Signal Design > DC-DC Converter

DC-DC Converter


Overview

U40LPDCDC1P1V1 is a high efficiency, low quiescent-current buck converter, suitable for applications where the input voltage is higher than the output. The buck converter is based on a fixed frequency, pulse-width-modulation (PWM) controller using synchronous rectification to obtain the highest efficiency. At low load currents, the converter enters Power Save Mode to maintain high efficiency over the complete load current range. The PFM pin allows the user to select between automatic-PFM/PWM mode operation and forced-PWM operation.

Features
  • Process: UMC 40nm Logic and Mixed-Mode 2.5V/1.1V Low Power Process
  • Efficiency: ~90% when IOUT=300mA (VIN=5V, considering the 100mΩ parasitic resistance of VIN and PGND respectively, 300mΩ parasitic resistance of VIN and AGND respectively and 100mΩ ESR of external inductor; if the parasitic resistance because of bonding, lead frame, PCB trace and ESR of external inductor is smaller, the efficiency will be higher.)
  • 3.3 V to 5.5 V Input voltage range
  • 0.3-A Max. output current: VIN ≥ 3.3 V, VOUT = 1.1 V
  • Typical switching frequency: ~1MHz
  • Standby current < 500 μA
  • Soft Start-up Time: max. 1ms from active to Vout=1.1V
  • Automatic power save mode or forced PWM mode
  • Over Current Protected: ~700mA
  • Over temperature protection:~150℃
  • Area < 460um x 555um
Functional Block Diagram


© 2024 虹晶科技股份有限公司 | SOCLE Technology Corp. Foxconn Technology Group.